Unlock Microcontroller PIC18F25K80 Binary

We can Unlock Microcontroller PIC18F25K80 Binary, please view the Microcontroller PIC18F25K80 features for your reference:

Power-Managed Modes:

ECAN Bus Module Features (Continued):

Run: CPU on, Peripherals on

Idle: CPU off, Peripherals on

Sleep: CPU off, Peripherals off

Two-Speed Oscillator Start-up when Unlock Microcontroller

Fail-Safe Clock Monitor (FSCM)

Power-Saving Peripheral Module Disable (PMD)

Ultra Low-Power Wake-up

Fast Wake-up, 1 ms, Typical if Unlock Microcontroller

Low-Power WDT, 300 nA, Typical

Run mode Currents Down to Very Low 3.8 mA, Typical

Idle mode Currents Down to Very Low 880 nA, Typical before Unlock Microcontroller

Sleep mode Current Down to Very Low 13 nA, Typical

ECAN Bus Module Features:

· Conforms to CAN 2.0B Active Specification

· Three Operating modes:

– Legacy mode (full backward compatibility with existing PIC18CXX8/FXX8 CAN modules) when Unlock Microcontroller

– Enhanced mode

– FIFO mode or programmable TX/RX buffers

· Message Bit Rates up to 1 Mbps

· DeviceNet™ Data Byte Filter Support if Unlock Microcontroller

· Six Programmable Receive/Transmit Buffers

· Three Dedicated Transmit Buffers with Prioritization

· Two Dedicated Receive Buffers

· 16 Full, 29-Bit Acceptance Filters with Dynamic Association when Unlock Microcontroller

· Three Full, 29-Bit Acceptance Masks

· Automatic Remote Frame Handling

· Advanced Error Management Features

· Operating Voltage Range: 1.8V to 5.5V

· On-Chip 3.3V Regulator before Unlock Microcontroller

· Operating Speed up to 64 MHz

· Up to 64 Kbytes On-Chip Flash Program Memory:

– 10,000 erase/write cycle, typical

– 20 years minimum retention, typical after Unlock Microcontroller

· 1,024 Bytes of Data EEPROM:

– 100,000 Erase/write cycle data EEPROM memory, typical

· 3.6 Kbytes of General Purpose Registers (SRAM)

· Three Internal Oscillators: LF-INTOSC (31 KHz),

MF-INTOSC (500 kHz) and HF-INTOSC (16 MHz) when Unlock Microcontroller

· Self-Programmable under Software Control

· Priority Levels for Interrupts

· 8 x 8 Single-Cycle Hardware Multiplier

· Extended Watchdog Timer (WDT):

– Programmable period from 4 ms to 4,194s if Unlock Microcontroller

· In-Circuit Serial Programming™ (ICSP™) via Two Pins

· In-Circuit Debug via Two Pins

· Programmable BOR

· Programmable LVD when Unlock Microcontroller


Tags: ,,,,,,,,,