IC Crack Service | MCU Crack Service | Microcontroller Unlock Service Provider

Power-Managed Modes:

Peripheral Highlights:

Run: CPU on, peripherals on

Idle: CPU off, peripherals on

Sleep: CPU off, peripherals off

Idle mode currents down to 5.8 ìA typical

Sleep mode currents down to 0.1 ìA typical

Timer1 Oscillator: 1.1 ìA, 32 kHz, 2V

Watchdog Timer: 2.1 ìA

Two-Speed Oscillator Start-up

High-Current Sink/source 25 mA/25 mA

Three External Interrupts

One Capture/Compare/PWM (CCP1) module

Enhanced Capture/Compare/PWM (ECCP1) module

(40/44-pin devices only):

– One, two or four PWM outputs

– Selectable polarity

– Programmable dead time

Flexible Oscillator Structure:

· Four Crystal modes, up to 40 MHz

· 4x Phase Lock Loop (PLL) – available for crystal and internal oscillators

· Two External RC modes, up to 4 MHz

· Two External Clock modes, up to 40 MHz

· Internal Oscillator Block:

– 8 user-selectable frequencies, from 31 kHz to 8 MHz

– Provides a complete range of clock speeds, from 31 kHz to 32 MHz when used with PLL

– User-tunable to compensate for frequency drift

· Secondary Oscillator using Timer1 @ 32 kHz

· Fail-Safe Clock Monitor

– Allows for safe shutdown if peripheral clock stops

– Auto-shutdown and auto-restart

Master Synchronous Serial Port (MSSP) module supporting 3-Wire SPI (all 4 modes) and I2C™

Master and Slave modes

Enhanced Addressable USART module:

– Supports RS-485, RS-232 and LIN 1.3

– RS-232 operation using internal oscillator block (no external crystal required)

– Auto-wake-up on Start bit

– Auto-Baud Detect

10-Bit, up to 11-Channel Analog-to-Digital

Converter module (A/D), up to 100 ksps:

– Auto-acquisition capability

– Conversion available during Sleep

Dual Analog Comparators with Input Multiplexing